Universal Bulb / Anchoring Light 12 V

Versatile, waterproof lamp with 4.5 m connection cable and cigarette lighter plug. The lamp is equipped with an electronic dimmer switch, which automatically turns the light on at dusk and turns it off during sufficient lighting. The lateral Fresnel lens of the lamp glass (plastic) provides a lateral beam range of up to 2 sm, the clear bottom lens illuminates the area below the lamp.
This small and lightweight lamp can be perfectly used as an energy-saving anchor lantern for preheating, as a card reading lamp, task light or orientation light.
The electrical connection is established via a 4.5 m long, highly flexible connection cable with cigarette lighter plug and integrated 1 A fuse. Delivery includes two bulbs, 1x 0.1 A (1.5 W) and 1x 0.24 A (3 W), a mounting device and a floating fuse holder.


Technical data

• Dimensions
  • Total length incl. cable outlet with strain relief and bend protection x max. Ø: 137 mm x 59 mm
  • Lens glass length x Ø Fresnel lens: 57 mm x 47 mm
• Weight incl. cable and plug: 210 g
• Latch lock: bayonet
• Lamp splash- and jet-proof
  • O-ring seal between housing and lamp glass
  • Crimp seal inside strain relief at the cable entry
• Connection cable
  • Length: approx. 4.5 m
  • Color: Black
  • Exterior Ø: 4 mm
  • Cable cross section 24 AWG (0.2 mm²)
• Lamp
  • Base: BA9S
  • Supplied bulbs: 12 V / 100 mA (approx. 1.5 W), 12 V / 240 mA (approx. 3 W)
• Current consumption of the electronic twilight switch with light off: approx. 10 mA
  (corresponds to 0.24 Ah/day or 7.2 Ah/month)
• Electrical connection:
  • Via cigarette lighter plug (Ø approx. 20 mm), 1 A built-in fuse (6.3 x 32 mm)
  • Firmly to the 12 volt electrical system, using the supplied fuse holder and the 1 A fuse from the plug.

Note

• We recommend the use of LED bulbs, e.g. item 12607. These use little power and shine more brightly.
• 12 Volt filament replacement bulbs can only have a max. of 5 watts of power consumption.
• To replace the bulb, the lens must be unlocked and removed from the front of the black lamp housing. Hold the lamp housing tight and turn the lamp glass (approx. 15°) counterclockwise until it stops. Then pull the lamp glass forward from the lamp housing.
  Due to the O-ring seal between the lamp housing and glass, a certain amount of force is required.
• When replacing the bulb, be careful not to damage the O-ring seal or contaminate the seal and seal areas of the lamp housing and glass.
• The lamp can be firmly connected to the 12 volt electrical system. To do this, remove the cigarette lighter plug and install the supplied flying fuse holder instead. The required 1 A fuse (6.3 x 32 mm) is to be located inside the cigarette lighter plug or you can find it in our assortment.
• Should the automatic dimming switch bother you, you can turn it off. Open the lamp glass and cover the sensor (located next to the lamp cap) with a dark insulating tape - the lamp will stay on all the time.